2010 Ford Fusion
Mileage
114,759
Service Date
8/16/2024
Services Performed
- STABILIZER BAR CONTROL LINK – Remove & Replace – Both
- STABILIZER BAR CONTROL LINK – Remove & Replace – FWD One
- TIE ROD &/OR END – Remove & Replace – One Side,Outer – [Includes: Adjust toe-in only. NOTE: Deduct .4 if alignment is also performed. NOTE: Manufacturer recommends removal of Rack and Pinion Steering Gear when replacing Inner Tie Rod End(s) on some models
- Check applicable alignment angles, adjust toe.
- CONTROL ARM – Remove & Replace – Lower,Left,Front – [DOES NOT include alignment.]
- CONTROL ARM – Remove & Replace – Lower,Right,Front – [DOES NOT include alignment.]
- ENGINE OR TRANSMISSION MOUNT – Remove & Replace – SE,SEL,V6,FWD Rear
- BRAKE SHOES &/OR PADS – Remove & Replace – Front or Rear – [Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include refinishing.]
- Check mechanical brake system for faulty or worn components and hydraulic system for worn or leaking components
- CALIPER – Remove & Replace – Rear,Both – [Includes: Bleed Brake System and replace Pads (if necessary).]
- Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean.
DAVID M. gave our service a 5 star review on 8/21/2024
